|
|
Istobal car wash configuration
Use Activa Direct Arming for the Istobal car washes.
Activa Direct Settings
In Activa Direct:
Set "Out-Of-Service when" to "Controller Power...
|
|
|
How to reprogram an Activa Bill Acceptor
This procedure describes how to reprogram an Activa bill acceptor. It assumes that the FP-001 Programmer device has already been loaded with the desired firmware program to...
|
|
|
|
|
|
Approved Wire and Uses
Ethernet (Internet) Wire
Run one Ethernet cable from the network access point (modem, router, switch...etc) to each Activa Virtual Attendant and to the Activa Site...
|
|
|
|
|
|
Activa Direct Wash Arming
Use Activa Direct arming to control the car wash through a direct wired connection to the Activa's I/O terminals.
To Select Activa Direct:...
|
|
|
|
|
|
Bill Acceptor troubleshooting
The Activa uses the A6 Series bill acceptor from International Currency Technologies (ICT). Documentation is attached. For dip switches under front panel of the acceptor...
|
|
|
Mark VII CombiWash configuration
Use Activa Direct Arming for the Mark VII CombiWash.
PLC Settings
Minimum firmware 3.28. On the PLC:
set module 60 (Entry System), parameter 13 to 002 -...
|
|
|
|
